Enhancement of growth and seed yield of rice (Oryza sativa L.) through foliar spray of osmoprotectants under high temperature stress
Abstract
An investigation was undertaken during rabi-summer season of 2016-17 in the Department of Seed Science and Technology, OUAT, Bhubaneswar to study the efficiency of some osmoprotectants in mitigating high temperature stress by improving growth, seed yield and quality of rice cv. Naveen. The field experiment was conducted in Split Plot Design, with three replications. The main plot factor was three dates of sowing (D1 – 30th November, D2 – 15th December and D3 – 30th December). The sub-plot factor was foliar spray of chemicals at vegetative and seed filling stages: Control (T0), 600 ppm Glycine betaine (T1), 400 ppm Salicylic acid (T2), 800 ppm Salicylic acid (T3), 10 ppm Ascorbic acid + 1.3% Citric acid (T4), 150 ppm α-Tocopherol (T5), 1.0% Potassium chloride (T6), 5 ppm Brassinolides (T7) and 10 ppm Brassinolides (T8). Observations on various phenological, seed yield and quality parameters were recorded. With advancement in sowing time, there was significant decrease in the chlorophyll content of leaves. The chlorophyll content of leaves after two days of spraying as slightly higher than that prior to spraying in all the treatments. Maximum chlorophyll content was recorded with spray treatment of 800 ppm salicylic acid at both the stages of observation. Significantly higher pollen viability and seed set were recorded with first date of sowing (D1), compared to second and third dates of sowing (D2 and D3, respectively). Among the treatments, pollen viability was highest with 10 ppm brassinolides and 400 ppm salicylic acid. Seed set was highest with 10 ppm brassinolides and 800 ppm salicylic acid. With advancement in sowing time, there was decrease in membrane stability index of leaves. The MSI of leaves after two days of spraying was slightly higher than that prior to spraying in all treatments. Maximum MSI was recorded with spray treatment of 400 ppm salicylic acid (T2) during vegetative and seed filling stages. The treatments T2, T4 and T8 produced highest increase in MSI compared to that before spraying during both stages. Higher seed yield was obtained from D1, compared to delayed sowing. Mean seed yield from D1 was 53.76 q/ha, as against 48.99 q/ha and 44.51 q/ha from D2 and D3, respectively. Spraying of 800 ppm salicylic acid and 10 ppm brassinolides gave highest seed yields from each date of sowing. Seed yields from D3T0 and D2T0 (35.33 q/ha and 39.72 q/ha, respectively) were significantly lower than all treatment combinations, including D1T0 (51.83 q/ha). Increase in seed yields due to various treatments as against the control was more pronounced in D2 and D3. The first date of sowing (D1) produced seeds with higher 1000-seed weight (22.62 g), compared to D2 and D3 (20.27 g and 19.36 g, respectively). Among the treatments, higher 1000-seed weights were recorded with the treatments T3 and T8 (21.51 g and 21.43 g, respectively), while lowest 1000-seed weight (18.76 g) was recorded with the Control. Seeds produced from D1 recorded higher germination and seed vigour. All the treatments recorded improvement in germination and vigour of seeds with three dates of sowing. Treatments T3, T7 and T8 gave highest improvement in seed germination over control. Under accelerated ageing treatment, T3 recorded highest germination followed by T8. Dates of sowing and treatment sprays had no influence on electrical conductivity of seed leachate. Hence, the present study demonstrated that foliar sprays at vegetative and seed filling stages with 800 ppm salicylic acid or 10 ppm ascorbic acid + 1.3% citric acid or 10 ppm brassinolides were quite effective in alleviating adverse effects of high temperature during flowering and seed set, through increased chlorophyll content of leaves, improved membrane stability, higher pollen viability and seed set, thus improving seed yield and quality of rice.
Keyword(s)
Full Text: PDF (downloaded 1066 times)
Refbacks
- There are currently no refbacks.